top of page

Two Rail Kit Instructions

ASSEMBLE THE KIT & CUT TO FIT

(Cedar or Douglas Fir)

Tools You’ll Need For Assembling Your Gate Kit:

000-tools-you-will-need.jpg

Step One:

  • Tape Measure

  • Wrench (1/2”)

  • Saw

  • Square

  • Pencil

  • Clear, flat area in which to work

  • Open package and place the two 60” horizontal runners parallel to each other on a flat surface with notches up.

  • Put a carriage bolt into each hole (6 total) with bolts sticking up. Be sure to align (aim) the diagonal brace notches so that the brace will be in the correct position.

001-step1.jpg

Step Two:

002-step2.jpg

Step Three:

  • Place the two 32” vertical uprights over the bolts and into the notches.

  • Place the diagonal brace over the bolts and into the notches. Attach the washers and nuts. You should now have a 60” X 32”rectangular frame having one foot cut tabs on each side.

003-step3.jpg
004-step4.jpg

Step Four:

  • Using a 1/2” wrench, tighten all nuts, drawing the carriage bolts into the wood. YOUR E-Z FIT GATE FRAME IS NOW ASSEMBLED! Simply measure the gate opening, fasten your pickets (fence boards), and cut away the excess cut tabs. Note: pickets should be placed on the opposite side of the washers and nuts. Your gate is now complete and ready for hanging.

bottom of page