E-Z Fit Gate Kit - Three Rail Kit Instructions

Three Rail Kit Instructions

ASSEMBLE THE KIT & CUT TO FIT

(Cedar or Douglas Fir)

Tools You’ll Need For Assembling Your Gate Kit:

Tape Measure
Wrench (1/2”)
Saw
Square
Pencil
Clear, flat area in which to work

Step One:

Open package and place the three 60” horizontal runners parallel to each other on a flat surface with notches up.
Put a carriage bolt into each hole (9 total) with bolts sticking up. Be sure to align (aim) the diagonal brace notches so that the brace will be in the correct position.

Step Two:

Place the two 54” vertical uprights over the bolts and into the notches.
Attach the washers and nuts. You should now have a 60” X 54” rectangular frame having one foot cut tabs on each side.

Step Three:

Place the diagonal brace over the bolts and into the notches. Attach the washers and nuts.

Step Four:

Using a 1/2” wrench, tighten all nuts, drawing the carriage bolts into the wood. YOUR E-Z FIT GATE FRAME IS NOW ASSEMBLED! Simply measure the gate opening, fasten your pickets (fence boards), and cut away the excess cut tabs. Note: pickets should be placed on the opposite side of the washers and nuts. Your gate is now complete and ready for hanging.

Page updated

Google Sites

Report abuse